992 CHAPTER 72: BGP CONFIGURATION COMMANDS
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test ebgp-max-hop
# In BGP-VPN instance view, allow establishing the EBGP connection with the peer
group test that is on an indirectly connected network (the VPN has been created).
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-vpn1] peer test ebgp-max-hop
peer enable (BGP view)
Syntax peer ip-address enable
undo peer ip-address enable
View BGP view
Parameters ip-address: IP address of a peer.
Description Use the
peer enable command to enable the specified peer.
Use the undo peer enable command to disable the specified peer.
By default, the BGP peer is enabled.
If a peer is disabled, the router will not exchange routing information with the
peer.
Examples # Disable peer 18.10.0.9.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer 18.10.0.9 group group1
[Sysname-bgp] undo peer 18.10.0.9 enable
peer fake-as (BGP/BGP-VPN instance view)
Syntax peer { group-name | ip-address } fake-as as-number
undo peer { group-name | ip-address } fake-as
View BGP view/BGP-VPN instance view
Parameters group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
as-number: Local autonomous system number, in the range 1 to 65535.
