1340 CHAPTER 87: MULTICAST ROUTING AND FORWARDING CONFIGURATION COMMANDS
multicast load-splitting
Syntax multicast load-splitting { source | source-group }
undo multicast load-splitting
View System view, VPN instance view
Parameter source: Specifies to implement per-source load splitting.
source-group: Specifies to implement per-source and per-group load splitting
simultaneously.
Description Use the
multicast load-splitting command to enable load splitting of multicast
traffic.
Use the
undo multicast load-splitting command to disable load splitting of
multicast traffic.
By default, load splitting of multicast traffic is disabled.
Example # Enable per-source load splitting of multicast traffic in the public instance.
<Sysname> system-view
[Sysname] multicast load-splitting source
# Enable per-source load splitting of multicast traffic in VPN instance mvpn.
<Sysname> system-view
[Sysname] ip vpn-instance mvpn
[Sysname-vpn-instance-mvpn] multicast load-splitting source
multicast longest-match
Syntax multicast longest-match
undo multicast longest-match
View System view, VPN instance view
Parameter None
Description Use the
multicast longest-match command to configure route selection based
on the longest match, namely based on the mask length.
Use the
undo multicast longest-match command to remove the configuration
of route selection based on the longest match.
By default, routes are selected according to the order of route entries.
