1938 CHAPTER 127: AAA CONFIGURATION COMMANDS
idle-cut
Syntax idle-cut { disable | enable minute }
View ISP domain view
Parameter disable: Disables the idle cut function.
enable minute: Enables the idle cut function. The minute argument refers to the
allowed idle duration, in the range 1 to 120 minutes.
Description Use the
idle-cut command to enable or disable the idle cut function.
By default, the function is disabled.
Related command: domain.
Example # Enable the idle cut function and set the idle threshold to 50 minutes for ISP
domain aabbcc.net.
<Sysname> system-view
[Sysname] domain aabbcc.net
[Sysname-isp-aabbcc.net] idle-cut enable 50
ip pool
Syntax ip pool pool-number low-ip-address [ high-ip-address ]
undo ip pool pool-number
View System view, ISP domain view
Parameter pool-number: Address pool number, in the range 0 to 99.
low-ip-address and high-ip-address: Start and end IP addresses of the address
pool. Up to 1024 addresses are allowed for an address pool. If you do not specify
the end IP address, there will be only one IP address in the pool, namely the start IP
address.
Description Use the
ip pool command to configure an address pool for assigning addresses to
PPP users.
Use the
undo ip pool command to delete an address pool.
By default, no IP address pool is configured for PPP users.
■ Configure an IP address pool in system view and use the remote address
command in interface view to assign IP addresses from the pool to PPP users.
