342 CHAPTER 21: BASIC DLSW CONFIGURATION COMMANDS
dlsw bridge-set
Syntax dlsw bridge-set bridge-set
undo dlsw bridge-set bridge-set
View System view
Parameter bridge-set: ID of the bridge set to be mapped to DLSw, in the range of 1 to 63.
Description Use the
dlsw bridge-set command to map the specified bridge set to DLSw.
Use the
undo dlsw bridge-set command to remove mapping between the
specified bridge set and DLSw.
By default, no bridge set is mapped to DLSw.
To enable forwarding frames of a bridge set to the remote end over a TCP
connection, the local bridge set needs to be mapped to DLSw through this
command. This command can be used repeated to map multiple bridge sets to
DLSw.
For details about bridge set configuration, refer to “Bridging Configuration
Commands” on page 549.
Example # Map the bridge set by the ID of 20 connected to DLSw.
<Sysname> system-view
[Sysname] bridge enable
[Sysname] bridge 20 enable
[Sysname] dlsw bridge-set 20
dlsw enable
Syntax dlsw enable
undo dlsw enable
View System view
Parameter None
Role Local role of LLC2 circuit
■ primary" represents the end that initiated the circuit
■ secondary" represents the end accepted the circuit connection
State State of the LLC2 circuit
Table 37 Description on the fields of the display llc2 command
Field Description
