1986 CHAPTER 129: HWTACACS CONFIGURATION COMMANDS
Description Use the secondary authorization command to specify the secondary
HWTACACS authorization server.
Use the
undo secondary authorization command to remove the
configuration.
Note that:
■ The IP addresses of the primary and secondary authorization servers cannot be
the same. Otherwise, the configuration fails.
■ The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
■ If you configure the command for more than one time, the last configuration
takes effect.
■ You can remove an authorization server only when no active TCP connection
for sending authorization packets is using it.
Related command: display hwtacacs.
Example # Configure the secondary authorization server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary authorization 10.163.155.13 49
stop-accounting-buffer enable (HWTACACS scheme view)
Syntax stop-accounting-buffer enable
undo stop-accounting-buffer enable
View HWTACACS scheme view
Parameter None
Description Use the
stop-accounting-buffer enable command to enable the device to
buffer stop-accounting requests getting no responses.
Use the
undo stop-accounting-buffer enable command to disable the device
from buffering stop-accounting requests getting no responses.
By default, the device is enabled to buffer stop-accounting requests getting no
responses.
Since stop-accounting requests affect the charge to users, a NAS must make its
best effort to send every stop-accounting request to the HWTACACS accounting
servers. For each stop-accounting request getting no response in the specified
period of time, the NAS buffers and resends the packet until it receives a response
or the number of transmission retries reaches the configured limit. In the latter
case, the NAS discards the packet.
