369
Use the undo sdlc timer lifetime command to restore the default setting.
By default, the secondary-station acknowledgment waiting time is 500
milliseconds.
Example # Set the secondary-station acknowledgment waiting time to 1,000 milliseconds
on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] sdlc timer lifetime 1000
sdlc timer poll
Syntax sdlc timer poll mseconds
undo sdlc timer poll
View Synchronous serial interface view
Parameter mseconds: SDLC polling interval in milliseconds. The effective range is 1 to 10,000.
Description Use the
sdlc timer poll command to configure the SDLC polling interval, namely
the amount of time the primary station waits between polling two secondary
stations.
Use the
undo sdlc timer poll command to restore the default setting.
By default, SDLC polling interval is 1,000 milliseconds.
Example # Set the SDLC polling interval to 200 milliseconds on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] sdlc timer poll 200
sdlc window
Syntax sdlc window length
undo sdlc window
View Synchronous serial interface view
Parameter length: The maximum number of consecutive frames the device can send before
receiving an acknowledgement from the peer, in the range of 1 to 7.
Description Use the
sdlc window command to configure the maximum number of
consecutive frames the device can send before receiving an acknowledgement
from the peer.
