1298 CHAPTER 84: IPV6 OSPFV3 CONFIGURATION COMMANDS
# Configure OSPFv3 process 100 to redistribute the routes found by OSPFv3
process 160.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] import-route ospfv3 160
log-peer-change
Syntax log-peer-change
undo log-peer-change
View OSPFv3 view
Parameters None
Description Use the
log-peer-change command to enable the logging on neighbor state
changes.
Use the
undo maximum load-balancing command to disable the logging.
With this feature enabled, information about neighbor state changes of the
current OSPFv3 process will display on the configuration terminal.
Examples # Disable the logging on neighbor state changes of OSPFv3 process 100.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] undo log-peer-change
maximum load-balancing(OSPFv3 view)
Syntax maximum load-balancing maximum
undo maximum load-balancing
View OSPFv3 view
Parameters maximum: Maximum number of load-balanced routes, in the range 1 to 8. The
argument being set to 1 means no load balancing is available.
Description Use the
maximum load-balancing command to configure the maximum
number of load-balanced routes.
Use the
undo maximum load-balancing command to restore the default.
Examples # Configure the maximum load-balanced routes as 6.
