1280 CHAPTER 84: IPV6 OSPFV3 CONFIGURATION COMMANDS
View OSPFv3 view
Parameters area-id: ID of an area, a decimal integer (in the range of 0 to 4294967295 and
changed to IPv4 address format by the system) or an IPv4 address.
Description Use the
area command to enter OSPFv3 area view.
n
The undo form of the command is not available. An area is removed automatically
if there is no configuration and no interface is up in the area.
Examples # Enter OSPFv3 Area 0 view.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 0
[Sysname-ospfv3-1-area-0.0.0.0]
default cost
Syntax default cost value
undo default cost
View OSPFv3 view
Parameters value: Specifies a default cost for redistributed routes, in the range of 1 to
16777214.
Description Use the
default cost command to configure a default cost for redistributed
routes.
Use the
undo default cost command to restore the default.
By default, the default cost is 1.
You need to configure the default cost value for redistributed routes to advertise
them throughout the whole AS.
If multiple OSPFv3 processes are available, use of this command takes effect for
the current process only.
Examples # Specify the default cost for redistributed routes as 10.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] default cost 10
default-cost (OSPFv3 area view)
Syntax default-cost value
