44
LOGICAL INTERFACE CONFIGURATION
COMMANDS
n
This section introduces basic configurations about logical interfaces. For the
configurations about the data link layer, the network layer and some special
features, refer to the relevant sections in Chapter 1 through Chapter 37 and
Chapter 46 through Chapter 70.
broadcast-limit link
Syntax broadcast-limit link number
undo broadcast-limit link
View Virtual template (VT) view
Parameter number: Maximum number of links that can send multicast or broadcast packets
in a VT. This argument ranges from 0 to 128 and defaults to 30. The value 0
indicates that multicast packets or broadcast packets cannot be sent.
Description Use the
broadcast-limit link command to set the maximum number of links
that can send multicast or broadcast packets in a VT. Use the undo
broadcast-limit link command to restore the default setting.
When a VT has plenty of links, the system performance will be decreased if all the
links send multicast or broadcast packets. In this case, you can use the
broadcast-limit link command to limit the maximum number of links that can
send multicast packets or broadcast packets.
Example # Set the maximum number of links that can send multicast or broadcast packets
in VT 1 to 100.
<Sysname> system-view
[Sysname] interface virtual-template 1
[Sysname-Virtual-Template1] broadcast-limit link 100
display interface loopback
Syntax display interface loopback [ number ]
View Any view
