69
IPV6 UNICAST POLICY ROUTING
CONFIGURATION COMMANDS
apply default output-interface
Syntax apply default output-interface interface-type interface-number
undo apply default output-interface [ interface-type interface-number ]
View IPv6 policy-based-route view
Parameter interface-type interface-number: Specifies an interface.
Description Use the
apply default output-interface command to set a default outgoing
interface for IPv6 packets.
Use the
undo apply default output-interface command to remove the
default outgoing interface.
This command only applies to packets not finding a match in the routing table.
You can specify up to five default outgoing interfaces, implementing load
balancing based on data streams.
Related command: apply ipv6-precedence, apply ipv6-address next-hop, apply
output-interface, apply ipv6-address default next-hop.
Example # Set the default outgoing interface to the interface Serial 2/0.
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply default output-interface serial 2/0
apply destination-based-forwarding
Syntax apply destination-based-forwarding
undo apply destination-based-forwarding
View IPv6 policy-based-route view
Parameter None
