A SERVICE OF

logo

67
DUAL STACK CONFIGURATION
COMMANDS
ipv6
Syntax ipv6
undo ipv6
View System view
Parameter None
Description Use the
ipv6 command to enable the IPv6 packet forwarding function.
Use the
undo ipv6 command to disable the IPv6 packet forwarding function.
By default, the function is disabled.
Example # Enable the IPv6 packet forwarding function.
<Sysname> system-view
[Sysname] ipv6
ipv6 address
Syntax ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }
undo ipv6 address [ ipv6-address prefix-length | ipv6-address/prefix-length ]
View Interface view
Parameter ipv6-address: IPv6 address for the interface.
prefix-length: Length of the prefix in bits, in the range of 1 to 128.
Description Use the
ipv6 address command to configure a site-local address or global
unicast address for an interface.
Use the
undo ipv6 address command to remove the configuration.
By default, neither site-local addresses nor global unicast addresses are configured.