1985
undo secondary authentication
View HWTACACS scheme view
Parameter ip-address: IP address of the server, a valid unicast address in dotted decimal
notation. The default is 0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to
49.
Description Use the
secondary authentication command to specify the secondary
HWTACACS authentication server.
Use the
undo secondary authentication command to remove the
configuration.
Note that:
■ The IP addresses of the primary and secondary authentication servers cannot be
the same. Otherwise, the configuration fails.
■ The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
■ If you configure the command for more than one time, the last configuration
takes effect.
■ You can remove an authentication server only when no active TCP connection
for sending authentication packets is using it.
Related command: display hwtacacs.
Example # Configure the secondary authentication server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary authentication 10.163.155.13 49
secondary authorization
Syntax secondary authorization ip-address [ por-number t ]
undo secondary authorization
View HWTACACS scheme view
Parameter ip-address: IP address of the server, a valid unicast address in dotted decimal
notation. The default is 0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to
49.
