59
IP ADDRESSING CONFIGURATION
COMMANDS
display ip interface
Syntax display ip interface [ interface-type interface-number ]
View Any view
Parameter interface-type interface-number: Specifies an interface by its type and number.
Description Use the
display ip interface command to display information about a specified
or all Layer 3 interfaces.
Example # Display detailed information about IP for interface Ethernet 1/0.
<Sysname> display ip interface ethernet 1/0
Ethernet1/0 current state : DOWN
Line protocol current state : DOWN
Internet Address is 1.1.1.1/8 Primary
Broadcast address : 1.255.255.255
The Maximum Transmit Unit : 1500 bytes
ip fast-forwarding incoming packets state is Disable
ip fast-forwarding outgoing packets state is Disable
input packets : 0, bytes : 0, multicasts : 0
output packets : 0, bytes : 0, multicasts : 0
ARP packet input number: 0
Request packet: 0
Reply packet: 0
Unknown packet: 0
TTL invalid packet number: 0
ICMP packet input number: 0
Echo reply: 0
Unreachable: 0
Source quench: 0
Routing redirect: 0
Echo request: 0
Router advert: 0
Router solicit: 0
Time exceed: 0
IP header bad: 0
Timestamp request: 0
Timestamp reply: 0
Information request: 0
Information reply: 0
Netmask request: 0
Netmask reply: 0
