455
x25 response called-address
Syntax x25 response called-address
undo x25 response called-address
View Interface view
Parameter None
Description Use the
x25 response called-address command to enable X.25 call reception
packets to carry the address information of the called DTE.
Use the
undo x25 response called-address command to disable the above
function.
By default, this function is disabled.
According to X.25, the call reception packet may or may not carry an address code
group, depending on the specific network requirements. This command enables
users to easily specify whether the packet carries the called DTE address.
Related command: x25 response calling-address, x25 ignore called-address, x25 ignore
calling-address.
Example # Specify that the call receiving packet of a call sent from the X.25 interface Serial
2/0 carries the called DTE address.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 response called-address
x25 response calling-address
Syntax x25 response calling-address
undo x25 response calling-address
View Interface view
Parameter None
Description Use the
x25 response calling-address command to enable X.25 to carry the
address information of the calling DTE in call reception packets
Use the
undo x25 response calling-address command to restore the default.
By default, this function is disabled.
