1193
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply mpls-label
apply origin
Syntax apply origin { igp | egp as-number | incomplete }
undo apply origin
View Routing policy view
Parameters igp: Sets the origin of BGP routing information to IGP.
egp: Sets the origin of BGP routing information to EGP.
as-number: Autonomous system number for EGP routes, in the range of 1 to
65535.
incomplete: Sets the origin of BGP routing information to unknown.
Description Use the
apply origin command to apply the specified origin attribute to BGP
routes.
Use the
undo apply origin command to remove the clause configuration.
No origin attribute is set for routing information by default.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip next-hop,
if-match cost, if-match tag, route-policy, apply ip-address next-hop, apply
local-preference, apply cost and apply tag.
Examples # Create routing policy policy1 with node 10, matching mode as permit. If a route
matches AS-path-ACL 1, set the origin for the route to IGP.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply origin igp
apply preference
Syntax apply preference preference
undo apply preference
View Routing policy view
Parameters preference: Routing preference, in the range of 1 to 255.
