A SERVICE OF

logo

173
Use the undo speed command to restore Ethernet interface data rate.
By default, Ethernet interface data rate is automatically negotiated between peer
Ethernet interfaces.
Note that the following:
The Combo port does not support the speed command.
The speed 1000 command is only applicable to Gigabit Ethernet interface.
Related command: duplex.
Example # Configure data rate for the interface Ethernet 1/0 to 100 Mbps.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] speed 100