366 CHAPTER 21: BASIC DLSW CONFIGURATION COMMANDS
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] sdlc sap-map local 08 05
sdlc sap-map remote
Syntax sdlc sap-map remote dsap sdlc-addr
undo sdlc sap-map remote dsap sdlc-addr
View Synchronous serial interface view
Parameter dsap: SAP address of the DLSw peer device, in the range of 0x01 to 0xFE.
sdlc-addr: SDLC address, in the range of 0x01 to 0xFE.
Description Use the
sdlc sap-map remote command to configure the SAP address of the
remote DLSw device for use in SDLC-to-LLC2 frame format conversion.
Use the
undo sdlc sap-map remote command to restore the system default.
By default, the SAP address of the remote DLSw device used in SDLC-to-LLC2
frame format conversion is 0x04.
When an SDLC frame is converted to an LLC2 frame, a SAP address is needed in
addition to the MAC address.
Generally speaking, the SAP address used by the SNA protocol is 0x04, 0x08 or
0x0C.
Related command: sdlc sap-map local.
Example # Configure the SAP address of the remote DLSw device for use in SDLC-to-LLC2
frame format conversion on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] sdlc sap-map remote 0C 05
sdlc simultaneous
Syntax sdlc simultaneous
undo sdlc simultaneous
View Synchronous serial interface view
Parameter None
