2608 CHAPTER 173: VOIP CONFIGURATION COMMANDS
send-ring
Syntax send-ring
undo send-ring
View Voice entity view
Parameter None
Description Use the
send-ring command to enable the local end to play ringback tone.
Use the
undo send-ring command to disable the local end to play ringback
tone.
By default, the local end does not play ringback tone.
In VoIP view, this command is applicable only after the fast connection function is
enabled. In POTS view, you can configure this command after you carry out the
line command to bind a voice entity to a trunk (other than FXS voice subscriber
line).
Example # Enable the local end to play ringback tone.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 voip
[Sysname-voice-dial-entity10] fast-connect
[Sysname-voice-dial-entity10] send-ring
shutdown (voice entity view)
Syntax shutdown
undo shutdown
View POTS/VoIP entity view
Parameter None
Description Use the
shutdown command to change the management status of the specified
voice entity from UP to DOWN.
Use the
undo shutdown command to restore the default management status of
the voice entity.
By default, the voice entity management status is UP.
Running command shutdown will cause the voice entity unable to make calls.
