1151
Use the undo ospf timer retransmit command to restore the default.
The interval defaults to 5s.
After sending a LSA, an interface waits for an acknowledgement packet. If the
interface receives no acknowledgement when the retransmit interval elapses, it
will retransmit the LSA.
The retransmit interval should not be so small to avoid unnecessary
retransmissions.
This configuration is not supported on the NULL interface.
Examples # Set the LSA retransmit interval to 8 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ospf timer retransmit 8
ospf trans-delay
Syntax ospf trans-delay seconds
undo ospf trans-delay
View Interface view
Parameters seconds: LSA transmit delay time in seconds, in the range 1 to 3600.
Description Use the
ospf trans-delay command to set the LSA transmit delay time on an
interface.
Use the
undo ospf trans-delay command to restore the default.
The delay time defaults to 1s.
Each LSA in the LSDB has an age (incremented 1 by a second), but a LSA is not
aged out during transmission. It is necessary to add a transmit delay into its age
time, which is important for transmission on low speed networks.
This configuration is not supported on the NULL interface.
Examples # Set the LSA transmit delay time to 3 seconds on the current interface.
<Sysname> system-view
[Sysname] interface serial2/0
[Sysname-Serial2/0] ospf trans-delay 3
peer
Syntax peer ip-address [ dr-priority dr-priority ]
