508 CHAPTER 31: PPP AND MP CONFIGURATION COMMANDS
<Sysname> system-view
[Sysname] interface mp-group 3
[Sysname-Mp-group3]
interface virtual-template
Syntax interface virtual-ethernet number
undo interface virtual-ethernet number
View System view
Parameter number: VT number, ranging from 0 to 1023.
Description Use the
interface virtual-template command to create a VT or enter VT view.
Use the
undo interface virtual-template command to remove a VT.
To remove a VT, make sure that all the relevant VA interfaces are removed and the
VT is not being used.
Example # Create VT 10 interface.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10]
ip address ppp-negotiate
Syntax ip address ppp-negotiate
undo ip address ppp-negotiate
View Interface view
Parameter None
Description Use the
ip address ppp-negotiate command to enable IP address negotiation
on the local interface, so that the local interface can accept the IP address
allocated by the remote end.
Use the
undo ip address ppp-negotiate command to disable IP address
negotiation.
By default, IP address negotiation is disabled.
Related command: remote address, ppp ipcp remote-address forced.
Example # Configure the IP address of interface Serial 1/0 to be negotiable.
