2262 CHAPTER 148: DEVICE MANAGEMENT COMMANDS
■ After you execute the above command, the device will prompt you to confirm
the configuration. You must enter <Y> or <y> to make the configuration take
effect. The original configuration will be overwritten at the same time.
■ If a date (month/day/year or year/month/day) later than the current date is
specified for the schedule reboot at command, the device will be rebooted at
the reboot time.
■ If you use the clock command after the schedule reboot at command to
adjust the system time, the reboot time set by the schedule reboot at
command will become invalid.
c
CAUTION: This command reboots the device in a future time, thus resulting in
service interruption. Please use it with caution.
Example # Configure the device to reboot at 12:00 AM (supposing that the current time is
11:43).
<Sysname> schedule reboot at 12:00
Reboot system at 12:00 2006/06/06(in 0 hour(s) and 16 minute(s))
confirm? [Y/N]:
# If you have used the terminal logging command to enable the log display
function on the terminal before setting a reboot time, the system will
automatically display related log information after you enter <y>. By default, the
log display function is enabled.
<Sysname>
%Jun 6 11:43:11:629 2006 Sysname CMD/5/REBOOT:
vty0(192.168.1.54): Set schedule reboot parameters at 11:43:11 2006/
06/06, and system will reboot at 12:00 2006/06/06.
schedule reboot delay
Syntax schedule reboot delay { hh:mm | mm }
undo schedule reboot
View User view
Parameters hh:mm: Device reboot wait time, in the format of hh:mm (hours:minutes). The
value of the hh argument ranges of is 0 to 720, and the value of the mm
argument ranges from 0 to 59, and the value of the hh:mm argument cannot
exceed 720:00.
mm: Device reboot wait time in minutes, in the range of 0 to 43,200.
Description Use the
schedule reboot delay command to enable the scheduled reboot
function and set a reboot wait time.
Use the
undo schedule reboot command to disable the scheduled reboot
function.
