1265
Examples # Clear the flap statistics of the routes matching AS path ACL 10.
<Sysname> system-view
[Sysname] ip as-path-acl 10 permit ^100.*200$
[Sysname] quit
<Sysname> reset bgp ipv6 flap-info as-path-acl 10
router-id
Syntax router-id router-id
undo router-id
View BGP view
Parameters router-id: Router ID in IP address format.
Description Use the
router-id command to specify a router ID for the router.
Use the
undo router-id command to remove a router ID.
To run IPv6 BGP protocol, a router must have a router ID, an unsigned 32-bit
integer and the unique ID of the router in the AS.
A router ID can be configured manually. If not, the system will select a router ID
automatically from the current interfaces’ IPv4 addresses. The selection sequence
is the highest IPv4 address of Loopback interfaces’ addresses, then the highest
IPv4 address of physical interfaces’ addresses if no Loopback interfaces are
configured.
Only when the interface with the router ID is removed or the manually configured
router ID is removed, will the system select another Router ID. To improve network
reliability, it is recommended to configure the IPv4 address of a loopback interface
as the router ID.
Examples # Specify the router ID of the router as 10.18.4.221.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] router-id 10.18.4.221
synchronization (IPv6 address family view)
Syntax synchronization
undo synchronization
View IPv6 address family view
Parameters None
