1125
# Display brief OSPF neighbor information.
<Sysname> display ospf peer
OSPF Process 1 with Router ID 1.1.1.1
Neighbor Brief Information
Area: 0.0.0.0
Router ID Address Pri Dead-Time Interface State
1.1.1.2 1.1.1.2 1 40 Eth0/1/0 Full/DR
display ospf peer statistics
Syntax display ospf [ process-id ] peer statistics
View Any view
Parameters process-id: OSPF process ID, in the range 1 to 65535.
Description Use the
display ospf peer statistics command to display OSPF neighbor
statistics.
State Neighbor state: Down, Init, Attempt, 2-Way, Exstart, Exchange,
Loading or Full
Mode Neighbor mode for DD exchange: Master or Slave
Priority Router priority
DR The DR on the interface’s network segment
BDR The BDR on the interface’s network segment
MTU Interface MTU
Dead timer due in 33 sec Dead timer times out in 33 seconds
Neighbor is up for
93:12:38
The neighbor has been up for 93:12:38
Authentication Sequence Authentication sequence number
Neighbor state change
count
Counts of neighbor state changes
Table 272 Description on the fields of the display ospf peer command
Field Description
Area Area of neighbors
Router ID Neighbor router ID
Address Neighbor interface address
Pri Router priority
Dead time Dead interval remained
Interface The Interface connected to neighbors
State Neighbor state: Down, Init, Attempt, 2-Way, Exstart,
Exchange, Loading or Full
Table 271 Description on the fields of the display ospf peer verbose command
Field Description
