2156 CHAPTER 141: IKE CONFIGURATION COMMANDS
display ike peer
Syntax display ike peer [ peer-name ]
View Any view
Parameter peer-name: Name of the IKE peer, a string of 1 to 15 characters.
Description Use the
display ike peer command to display information about a specified or
all IKE peers.
Related command: ike peer (system view).
Example # Display information about all IKE peers.
<Sysname> display ike peer
---------------------------
IKE Peer: rtb4tunn
exchange mode: main on phase 1
pre-shared-key: 123
peer id type: ip
peer ip address: 44.44.44.55
local ip address:
peer name:
nat traversal: disable
dpd: dpd1
---------------------------
display ike proposal
Syntax display ike proposal
View Any view
Parameter None
Table 570 Description on the fields of the display ike peer command
Field Description
exchange mode IKE negotiation mode in phase 1
pre-shared-key Pre-shared key used in phase 1
peer id type ID type used in phase 1
peer ip address IP address of the remote security gateway
local ip address IP address of the local security gateway
peer name Name of the remote security gateway
nat traversal Whether NAT traversal is enabled
dpd Name of the peer DPD
