1959
Use the undo primary accounting command to restore the defaults.
By default, the default IP address is 0.0.0.0, and the default port number 1813.
Note that:
■ The IP addresses of the primary and secondary accounting servers cannot be
the same. Otherwise, the configuration fails.
■ The RADIUS service port configured on the device and that of the RADIUS
server must be consistent.
Related command: key (RADIUS scheme view), radius scheme, state.
Example # Set the IP address of the primary accounting server for RADIUS scheme radius1
to 10.110.1.2 and the UDP port of the server to 1813.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] primary accounting 10.110.1.2 1813
primary authentication (RADIUS scheme view)
Syntax primary authentication ip-address [ port-number ]
undo primary authentication
View RADIUS scheme view
Parameter ip-address: IP address of the primary authentication/authorization server.
port-number: UDP port number of the primary authentication/authorization
server, which ranges from 1 to 65535.
Description Use the
primary authentication command to configure the IP address and UDP
port of the primary RADIUS authentication/authorization server.
Use the
undo primary authentication command to restore the defaults.
By default, the default IP address is 0.0.0.0, and the default port number 1812.
Note that:
■ After creating a RADIUS scheme, you are supposed to configure the IP address
and UDP port of each RADIUS server (primary/secondary
authentication/authorization or accounting server). The configuration of
RADIUS servers is at your discretion except that there must be at least one
authentication/authorization server and one accounting server. Besides, ensure
that the RADIUS service port settings on the device are consistent with the port
settings on the RADIUS servers.
■ The IP addresses of the primary and secondary authentication/authorization
servers cannot be the same. Otherwise, the configuration fails.
