22
FRAME RELAY CONFIGURATION
COMMANDS
annexg
Syntax annexg {dce | dte}
undo annexg {dce | dte}
View DLCI interface view
Parameter dce: Specifies the DLCI interface as an Annex G DTE interface.
dte: Specifies the DLCI interface as an Annex G DCE interface.
Description Use the
annexg command to configure the operating mode (Annex G DCE or
Annex DTE) for a DLCI interface.
Use the
undo annexg command to remove the configuration.
By default, a DLCI interface does operate in the Annex G DCE mode.
ANSI T1.617 Annex G defines the way to transmit X.25 packets using FR virtual
circuits. Similar to normal X.25 interface, an Annex G interface transmits/receives
X.25 PVC and X.25 SVC packets and can operate as an X.25 switching interface.
You can set LAPB-/X.25-related parameters for a virtual circuit by applying an X.25
template to it.
Example # Create an Annex G DTE interface.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] fr dlci 100
[Sysname-fr-dlci-Serial2/0-100] annexg dte
display fr compress
Syntax display fr compress [interface interface-type interface-number]
View Any view
Parameter interface interface-type interface-number: Specifies an interface by its type and
number.
