1073
n
This command is not available in loopback interface view.
Examples # Configure the interval as 500 milliseconds for sending LSPs on interface serial
2/0.
<Sysname> system-view
[Sysname] interface serial2/0
[Sysname-Serial2/0] isis timer lsp 500
isis timer retransmit
Syntax isis timer retransmit seconds
undo isis timer retransmit
View Interface view
Parameters seconds: Specifies the interval in seconds for retransmitting LSP packets, ranging
from 1 to 300.
Description Use the
isis timer retransmit command to configure the interval for
retransmitting LSP packets over point-to-point link.
Use the
undo isis timer retransmit command to restore the default of 5s.
You need not use this command over a broadcast link where no LSP response is
required.
Related commands: isis timer lsp.
n
■ This command is not available in loopback interface view.
■ Configure a proper time to avoid unnecessary retransmissions.
Examples # Configure the LSP retransmission interval as 10 seconds for the serial2/0
interface.
<Sysname> system-view
[Sysname] interface serial2/0
[Sysname-Serial2/0] isis timer retransmit 10
is-level
Syntax is-level { level-1 | level-1-2 | level-2 }
undo is-level
View IS-IS view
