1175
password: Plain text authentication string with 1 to 16 characters.
Description Use the
rip authentication-mode command to configure RIP-2 authentication
mode and parameters.
Use the
undo rip authentication-mode command to cancel authentication.
Note that the key string you configured can overwrite the old one if there is any.
Related commands: rip version.
n
With RIPv1, you can configure the authentication mode in interface view.
However, the configuration will not take effect because RIPv1 does not support
authentication.
Examples # Configure MD5 authentication on Ethernet1/0 with the key string being rose in
the format defined in RFC 2453.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] rip version 2
[Sysname-Ethernet1/0] rip authentication-mode md5 rfc2453 rose
rip input
Syntax rip input
undo rip input
View Interface view
Parameters None
Description Use the
rip input command to enable the interface to receive RIP messages.
Use the undo rip input command to disable the interface from receiving RIP
messages.
By default, an interface is enabled to receive RIP messages.
Related commands: rip output.
Examples # Enable Ethernet1/0 to receive RIP messages.
<Sysname> system-view
[Sysname] interface ethernet1/0
[Sysname-Ethernet1/0] rip input
