2620 CHAPTER 173: VOIP CONFIGURATION COMMANDS
Related command: display version on page 2417, and display device on page 2251.
c
CAUTION: You can use this command to reset only the analog voice cards of SIC
and MIM. To reset digital voice card and FIC analog voice card, carry out the
reboot slot slot-number command in system view.
Example # Reset the voice card of slot 3.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] vi-card reboot 3
voice-setup
Syntax voice-setup
View System view
Parameter None
Description Use the
voice-setup command to enter voice view and enable voice services.
Example # Enter voice view and enable voice services.
<Sysname> system-view
[Sysname] voice-setup
voip called-tunnel enable
Syntax voip called-tunnel enable
undo voip called-tunnel enable
View Voice view
Parameter None
Description Use the
voip calledtunnel enable command to enable the tunnel function on
the called gateway.
Use the
undo voip calledtunnel enable command to disable the tunnel
function on the called gateway.
By default, the tunnel function on the called gateway is enabled.
Related command: tunnel-on.
n
If the voip called-start normal command is configured, the voip called-tunnel
enable command is unavailable.
