2571
By default, the delay signal duration is 400 milliseconds.
Related command: em-signal.
Example # Set the delay signal duration in the delay start mode to 500 seconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] em-signal delay
[Sysname-voice-line1/0] delay hold 500
delay rising
Syntax delay rising milliseconds
undo delay rising
View E&M voice subscriber line view
Parameter rising milliseconds: Specifies delay time (in milliseconds) from when the
terminating side detects a seizure signal to when it sends a delay signal in the
delay start mode. The value ranges from 20 to 2,000.
Description Use the
delay rising command to configure a delay time from when the
terminating side detects a seizure signal to when it sends a delay signal in the
delay start mode.
Use the
undo delay rising command to restore the default.
By default, the delay time is 300 milliseconds.
Related command: em-signal.
Example # Set the delay time from when the terminating side detects a seizure signal to
when it sends a delay signal in the delay start mode to 700 milliseconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] em-signal delay
[Sysname-voice-line1/0] delay rising 700
delay send-dtmf
Syntax delay send-dtmf milliseconds
undo delay send-dtmf
View E&M voice subscriber line view
