133
NAT CONFIGURATION COMMANDS
connection-limit default action
Syntax connection-limit default action [ permit | deny ]
undo connection-limit default action
View System view
Parameter permit: Enables the connection-limit function globally.
deny: Disables the connection-limit function globally.
Description Use the
connection-limit default action command to specify the default
connection-limit action globally, either permit or deny. The effect of this command
applies to all user connections not defined in the connection-limit policy.
Use the
undo connection-limit default command to restore the default.
By default, connection-limit is not enabled.
Example # Configure the default connection-limit action as permit.
<Sysname> system-view
[Sysname] connection-limit default action permit
connection-limit default amount
Syntax connection-limit default amount { upper-limit max-amount | lower-limit
min-amount } *
undo connection-limit default amount
View System view
Parameter upper-limit max-amount: Specifies the upper limit of connections, in the range 1
to 4294967295.
lower-limit min-amount: Specifies the lower limit of connections, a value smaller
than the upper limit, in the range 0 to 4294967295.
