1439
source-group: Specifies to implement IPv6 multicast load splitting on a per-source
and per-group basis.
Description Use the multicast load-splitting command to enable load splitting of IPv6
multicast traffic.
Use the
undo multicast load-splitting command to disable load splitting of
IPv6 multicast traffic.
By default, load splitting of IPv6 multicast traffic is disabled.
Example # Enable load splitting of IPv6 multicast traffic on a per-source basis.
<Sysname> system-view
[Sysname] multicast ipv6 load-splitting source
multicast ipv6 longest-match
Syntax multicast ipv6 longest-match
undo multicast ipv6 longest-match
View System view
Parameter None
Description Use the
multicast ipv6 longest-match command to configure route selection
based on the longest match, namely based on the prefix length.
Use the
undo multicast ipv6 longest-match command to remove the
configuration of route selection based on the longest match.
By default, routes are selected in order of routing entries.
Example # Configure route selection based on the longest match.
<Sysname> system-view
[Sysname] multicast ipv6 longest-match
multicast ipv6 minimum-hoplimit
Syntax multicast ipv6 minimum-hoplimit ttl-value
undo multicast ipv6 minimum-hoplimit
View Interface view
Parameter hoplimit-value: Minimum hop limit required for an IPv6 multicast packet to be
forwarded on the interface, in the range of 1 to 255.
