1630 CHAPTER 96: MPLS TE CONFIGURATION COMMANDS
View Tunnel interface view
Parameter label: Includes the record of labels in the route record. This keyword is not
supported when the signaling protocol is CR-LDP. This keyword is not supported
when the signaling protocol is CR-LDP.
Description Use the mpls te record-route command to enable route recording or label
recording.
Use the
undo mpls te record-route command to restore the default.
By default, route recording and label recording are disabled.
Example # Enable route recording on MPLS TE tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te record-route
mpls te reoptimization (user view)
Syntax mpls te reoptimization
View User view
Parameter None
Description Use the
mpls te reoptimization command to start reoptimizing all
reoptimization-enabled TE tunnels.
Example # Start reoptimizing all reoptimization-enabled TE tunnels.
<Sysname> mpls te reoptimization
mpls te reoptimization (tunnel interface view)
Syntax mpls te reoptimization [ frequency seconds ]
undo mpls te reoptimization
View Tunnel interface view
Parameter seconds: Reoptimization frequency, in the range 1 to 604800 seconds. The default
is 3600 seconds, or 1 hour.
Description Use the
mpls te reoptimization command to enable reoptimization on the
tunnel.
