A SERVICE OF

logo

1448 CHAPTER 92: MLD CONFIGURATION COMMANDS
Example # Globally set the maximum response delay for general queries to 8 seconds.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] max-response-time 8
mld
Syntax mld
undo mld
View System view
Parameter None
Description Use the
mld command to enter MLD view.
Use the undo mld command to remove the configurations done in MLD view.
This command can take effect only after IPv6 multicast routing is enabled on the
device.
Related command: mld enable, and multicast ipv6 routing-enable on page 1440.
Example # Enter MLD view.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] mld
[Sysname-mld]
mld enable
Syntax mld enable
undo mld enable
View Interface view
Parameter None
Description Use the
mld enable command to enable MLD on the current interface.
Use the
undo mld enable command to disable MLD on the current interface.
By default, MLD is disabled on the current interface.
Note that: