1429
Use the undo timer join-prune command to restore the default setting.
By default, the join/prune interval is 60 seconds.
Related command: pim timer join-prune.
Example # Set the global join/prune interval to 80 seconds in the public instance.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer join-prune 80
timer spt-switch (PIM view)
Syntax timer spt-switch interval
undo timer spt-switch
View Public instance PIM view, VPN instance PIM view
Parameter interval: Interval in seconds between checks of the traffic rate threshold prior to
RPT-to-SPT switchover, in the range of 15 to 65,535.
Description Use the
timer spt-switch command to configure the interval between checks of
the traffic rate threshold before RPT-to-SPT switchover.
Use the
undo timer spt-switch command to restore the default setting.
By default, the traffic rate threshold is checked at an interval of 15 seconds before
RPT-to-SPT switchover.
Before using this command, be sure to use the spt-switch-threshold command
to configure the traffic rate threshold that should trigger RPT-to-SPT switchover.
Otherwise, the interval set in this command will be meaningless.
Related command: spt-switch-threshold (PIM view).
Example # In the public instance set the interval between checks of the traffic rate
threshold prior to RPT-to-SPT switchover to 30 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer spt-switch 30
