68
TUNNELING CONFIGURATION
COMMANDS
n
A tunnel interface number is in the X format, where X ranges from 0 to 1023.
destination
Syntax destination { ip-address | ipv6-address }
undo destination
View Tunnel interface view
Parameter ip-address: Destination IPv4 address of a specified tunnel interface.
ip-address: Destination IPv6 address of a specified tunnel interface.
Description Use the command destination to specify a destination address for the tunnel
interface.
Use the
undo destination command to remove the configured destination IP
address.
By default, no destination address is configured for the tunnel interface.
Note that:
■ The destination address of a tunnel interface is the address of the peer
interface receiving packets and is usually the source address of the peer tunnel
interface.
■ Two or more tunnel interfaces using the same encapsulation protocol must
have different source and destination addresses.
Related command: interface tunnel and source.
Example # Set Serial2/0 (193.101.1.1) of Sysname 1 and Serial2/0 (192.100.1.1) of
Sysname 2 to the source and destination interfaces of a tunnel between two
devices, respectively.
<Sysname1> system-view
[Sysname1] interface tunnel 0
[Sysname1-Tunnel0] source 193.101.1.1
[Sysname1-Tunnel0] destination 192.100.1.1
<Sysname2> system-view
