1180 CHAPTER 77: RIP CONFIGURATION COMMANDS
undo rip triggered
View Interface view
Parameters None
Description Use the
rip triggered command to enable triggered RIP.
Use the undo rip triggered command to disable triggered RIP.
By default, the triggered RIP is disabled.
Note that triggered RIP can only run on link layer protocols PPP, Frame Relay, and
X.25.
Examples # Enable triggered RIP.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] rip triggered
rip version
Syntax rip version { 1 | 2 [ broadcast | multicast ]}
undo rip version
View Interface view
Parameters 1: RIP version 1.
2: RIP version 2.
broadcast: Sends RIP-2 messages in broadcast mode.
multicast: Sends RIP-2 messages in multicast mode.
Description Use the
rip version command to specify a RIP version for the interface.
Use the
undo rip version command to remove the specified RIP version.
By default, no RIP version is configured for an interface, which uses the global RIP
version. If the global RIP version is not configured, the interface can only send
RIP-1 broadcasts and can receive RIP-1 broadcasts and unicasts, and RIP-2
broadcasts, multicasts and unicasts.
If RIP-2 is specified with no sending mode configured, RIP-2 messages will be sent
in multicast mode.
When RIP-1 runs on an interface, the interface will:
