416 CHAPTER 24: GVRP CONFIGURATION COMMANDS
display gvrp status
Syntax display gvrp status
View Any view
Parameter None
Description Use the
display gvrp status command to display the global enable/disable state
of GVRP.
Example # Display the global GVRP enable/disable state.
<Sysname> display gvrp status
GVRP is enabled
gvrp
Syntax gvrp
undo gvrp
View System view, Ethernet interface view, port group view
Parameter None
Description Use the
gvrp command to enable GVRP.
Use the undo gvrp command to disable GVRP.
Disabling GVRP globally also disables it on all ports.
By default, GVRP is disabled.
Configured in system view, the setting is globally effective; configured in Ethernet
interface view, the setting is effective on the current port only; configured in port
group view, the setting is effective on all ports in the port group.
n
■ To enable GVRP on a port, you need to enable it globally.
■ The port where you enable/disable GVRP must be a trunk port.
Related command: display gvrp status.
Example # Enable GVRP globally.
<Sysname> system-view
[Sysname] gvrp
GVRP is enabled globally.
