2167
Description Use the interval-time command to set the DPD query triggering interval for a
DPD.
Use the
undo interval-time command to restore the default.
By default, the DPD query triggering interval is 10 seconds.
Example # Set the DPD query triggering interval for dpd2 to 1 second.
<Sysname> system-view
[Sysname] ike dpd dpd2
[Sysname-ike-dpd-dpd2] interval-time 1
local
Syntax local { multi-subnet | single-subnet }
undo local
View IKE peer view
Parameter multi-subnet: Sets the subnet type to multiple.
single-subnet: Sets the subnet type to single.
Description Use the
local command to set the subnet type of the local gateway for IKE
negotiation.
Use the
undo local command to restore the default.
By default, the subnet is a single one. You can use this command to enable
interoperability with a Netscreen device.
Example # Set the subnet type of the local gateway to multiple.
<Sysname> system-view
[Sysname] ike peer xhy
[Sysname-ike-peer-xhy] local multi-subnet
local-address
Syntax local-address ip-address
undo local-address
View IKE peer view
Parameter ip-address: IP address of the local gateway in IKE negotiation.
