1428 CHAPTER 90: PIM CONFIGURATION COMMANDS
■ You can configure up to 50 static RPs on the same device.
Related command: display pim rp-info and auto-rp enable.
Example # In the public instance, configure the interface with the IP address 11.110.0.6 to
be a static RP that serves the multicast groups defined in ACL 2001, and give
priority to this static RP in the case of static/dynamic RP conflict.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] static-rp 11.110.0.6 2001 preferred
timer hello (PIM view)
Syntax timer hello interval
undo timer hello
View Public instance PIM view, VPN instance PIM view
Parameter interval: Hello interval in seconds, with an effective range of 1 to 2,147,483,647.
Description Use the
timer hello command to configure the hello interval globally.
Use the
undo timer hello command to restore the default setting.
By default, hello messages are sent at the interval of 30 seconds.
Related command: pim timer hello.
Example # Set the global hello interval to 40 seconds in the public instance.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer hello 40
timer join-prune (PIM view)
Syntax timer join-prune interval
undo timer join-prune
View Public instance PIM view, VPN instance PIM view
Parameter interval: Join/prune interval in seconds, with an effective range of 1 to
2,147,483,647.
Description Use the
timer join-prune command to configure the join/prune interval globally.
