27
LINK AGGREGATION CONFIGURATION
COMMANDS
n
Link aggregation is not supported on MSR 20 series routers. It is only supported on
the interfaces of 16FSW/24FSW modules of MSR 30/MSR 50 series routers.
display lacp system-id
Syntax display lacp system-id
View Any view
Parameter None
Description Use the
display lacp system-id command to display the local system ID (also
called the actor system ID), which comprises the system LACP priority and the
system MAC address.
Example # Display the local system ID.
<Sysname> display lacp system-id
Actor System ID: 0x8000, 00e0-fc00-0100
display link-aggregation interface
Syntax display link-aggregation interface interface-type interface-number [ to interface-type
interface-number ]
View Any view
Parameter interface interface-type interface-number [ to interface-type interface-number ]:
Specifies a port range or a port if the to keyword and the second port are not
specified.
Description Use the display link-aggregation interface command to display detailed
information about link aggregation for the specified port or ports.
You may find that information about the remote system is replaced by 0 and no
statistics about LACPDUs are provided for manual link aggregation groups. This is
normal because this type of aggregation group has no knowledge of its partner
and does not use LACP PDUs for maintaining link aggregation.
