2465
<Sysname> system-view
[Sysname] user-interface vty 0 4
[Sysname-ui-vty0-4] authentication-mode scheme
[Sysname-ui-vty0-4] protocol inbound ssh
redirect disconnect
Syntax redirect disconnect
View User interface view
Parameter None
Description Use the
redirect disconnect command to manually terminate a redirected telnet
connection.
n
■ The redirect commands are supported on the AUX and TTY user interfaces
only.
■ Execute the command after using the redirect enable command to enable
redirection on the user interface.
Example # Manually terminate a redirected Telnet connection.
<Sysname> system-view
[Sysname] user-interface tty 1
[Sysname-ui-tty1] redirect disconnect
redirect enable
Syntax redirect enable
undo redirect enable
View User interface view
Parameter None
Description Use the
redirect enable command to enable redirection on the active
asynchronous serial interface.
Use the
undo redirect enable command to disable this function.
By default, the redirection function is disabled.
n
■ The redirect commands are supported on the AUX and TTY user interfaces
only.
■ To use the redirection function or configure redirection-related parameters, use
this command to enable redirection on the user interface.
