146 CHAPTER 6: ADSL INTERFACE CONFIGURATION COMMANDS
Use the all keyword with caution. In case failure occurs, recovery is difficult and
troublesome.
Note that:
■ Only distributed devices support the slot slot-no-list option.
■ The subslot subslot-no-list option is not available if the device does not
support the sub-card-level maintenance.
Example # Upgrade software for an ADSL2+ card.
<Sysname> system-view
[Sysname]interface atm 2/0
[Sysname-Atm2/0]shutdown
[Sysname-Atm2/0] quit
[Sysname] quit
<Sysname> bootrom update file flash:/bcm6348.bin slot 1 part
This command will update BootRom file on board 2, Continue? [Y/N]y
Board 2 upgrading BOOTROM, please wait...
<Sysname> system-view
[Sysname]interface atm 2/0
[Sysname-Atm2/0]undo shutdown
display dsl configuration
Syntax display dsl configuration interface atm interface-number
View Any view
Parameter interface-number: Specifies a DSL interface to view the configuration information
about.
Description Use the
display dsl configuration command to display the configuration of a
DSL interface.
Example # Display the actual configurations of ADSL interface ATM 2/0.
<Sysname> display dsl configuration interface atm 2/0
Line Params Set by User
Standard: T1.413
Annex: A
Framing: 3
Coding Gain(dB): Auto
Tx Pow Attn(dB): 0
Bit-Swap: disable
LinkCheck: Enable
Actual Config Near End Far End
Standard: T1.413 T1.413
Trellis Coding: Enable Enable
Framing: 3 3
Vendor ID: 0x0039 0x0004
