2290 CHAPTER 150: NQA SERVER CONFIGURATION COMMANDS
nqa server enable
Syntax nqa server enable
undo nqa server enable
View System view
Parameter None
Description Use the
nqa server enable command to enable the NQA server.
Use the
undo nqa server enable command to disable the NQA server.
By default, the NQA server is disabled.
Related command: nqa server tcp-connect, nqa server udp-echo.
Example # Enable the NQA server.
<Sysname> system-view
[Sysname] nqa server enable
nqa server tcp-connect
Syntax nqa server tcp-connect ip-address port-number
undo nqa server tcp-connect ip-address port-number
View System view
Parameter ip-address: IP address specified for the TCP listening service on the NQA server.
port-number: Port number specified for the TCP listening service on the NQA
server, in the range 1 to 50000.
Description Use the
nqa-server tcp-connect command to create a TCP listening service on
the NQA server.
Use the
undo nqa-server tcp-connect command to remove the TCP listening
service created.
Status Listening service status:
active: Listening service is ready;
inactive: Listening service is not ready.
Table 602 Description on the fields of the display nqa server status command
Field Description
