584 CHAPTER 37: ISDN CONFIGURATION COMMANDS
Example # Configure the slide window size on the interface CE1/PRI 1/0 to 10.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-E1 1/0] using ce1
[Sysname-E1 1/0] quit
[Sysname]interface serial 1/0:15
[Sysname-Serial1/0:15] isdn pri-slipwnd-size 10
isdn protocol-mode
Syntax isdn protocol-mode { network | user }
undo isdn protocol-mode
View Interface view
Parameter mode: ISDN protocol mode to be set, which can be network (for network side
mode) and user (for user side mode).
Description Use the
isdn protocol-mode command to set the protocol mode for an ISDN
interface.
Use the
undo isdn protocol-mode command to restore the default protocol
mode.
By default, an ISDN interface operates in the user side mode.
Example # Set the protocol mode to network side mode for BRI 2/0 interface (assuming
that the interface is a BSV interface).
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn protocol-mode network
isdn protocol-type
Syntax isdn protocol-type protocol
undo isdn protocol-type
View ISDN interface view
Parameter protocol: ISDN protocol, which can be ANSI,AT&T, DSS1, ETSI, NI, NI2,NTT, or
QSIG.
Description Use the
isdn protocol-type command to set the ISDN protocol to be run on an
ISDN interface.
Use the
undo isdn protocol-type command to restore the default.
