173
VOIP CONFIGURATION COMMANDS
n
The voice subscriber line in this chapter refers to a digital or analog subscriber line,
unless otherwise specified.
address
Syntax address { ip ip-address | ras | sip { ip ip-address [ port port-number ] | proxy }}
undo address { ip | ras | sip { ip | proxy }}
View VoIP entity view
Parameter ip ip-address: IP address of the terminating gateway, namely, the destination
address of a VoIP entity.
ras: Uses RAS messages to interact with the GK server so as to find the mapping
between the phone number and the IP address. They are used only in the
networking configuration that uses a gatekeeper (GK) to provide IP voice services.
sip: Uses the SIP.
port port-number: Port number, in the range of 1 to 65535. The default port
number is 5060.
proxy: Uses the SIP proxy server to implement SIP message exchange.
Description Use the
address command to configure a policy for the routing between the VoIP
entity and the terminating voice gateway.
Use the
undo address command to remove the routing policy that has been
configured.
By default, no policy is configured for routing from the VoIP entity to the peer VoIP
gateway.
Related command: match-template.
Example # Configure the H.323 direct routing for voice entity 10 with the called number
1234 in its match template, and set the IP address of the terminating gateway to
10.1.1.2.
<Sysname> system-view
[Sysname] voice-setup
