71
IP ROUTING TABLE COMMANDS
bandwidth-based-sharing
Syntax bandwidth-based-sharing
undo bandwidth-based-sharing
View System view
Parameters None
Description Use the
bandwidth-based-sharing command to enable bandwidth-based load
sharing.
Use the
undo bandwidth-based-sharing command to disable
bandwidth-based load sharing.
By default, bandwidth-based load sharing is disabled.
If multiple outbound interfaces/nexthops to a destination are found during
forwarding:
■ When bandwidth-based load sharing is disabled, the packets are forwarded
through all these interfaces in turn.
■ When bandwidth-based load sharing is enabled, the device calculates the
packet forwarding proportion for each interface based on the bandwidths and
then determines through which interfaces to forward the subsequent packets
(the number of packets already forwarded through these interfaces is
considered).
Examples # Enable bandwidth-based load sharing.
<Sysname> system-view
[Sysname] bandwidth-based-sharing
display ip routing-table
Syntax display ip routing-table [ vpn-instance vpn-instance-name ] [ verbose ] | { begin |
exclude | include } regular-expression ]
View Any view
