1013
Use the undo timer command to restore the default.
By default, BGP keepalive and holdtime intervals are 60s and 180s.
Note that:
■ Timer configured using the peer timer command is preferred to the timer
configured using this command.
■ The holdtime interval must be at least three times the keepalive interval.
■ The configured timer applies to all the BGP peers, while it becomes valid only
after the corresponding BGP connections are reset.
Related commands: peer timer (BGP/BGP-VPN instance view).
Examples # Configure keepalive interval and holdtime interval as 60s and 180s.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] timer keepalive 60 hold 180
# In BGP-VPN instance view, configure keepalive interval and holdtime interval as
60s and 180s (the VPN has been created).
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-vpn1] timer keepalive 60 hold 180
