1493
Parameter interval: Maximum delay in seconds between hello messages, with an effective
range of 1 to 5.
Description Use the pim ipv6 triggered-hello-delay command to configure the maximum
delay between hello messages.
Use the
undo pim ipv6 triggered-hello-delay command to restore the
default setting.
By default, the maximum delay between hello messages is 5 seconds.
Example # Set the maximum delay between hello messages to 3 seconds on Ethernet 1/0.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] pim ipv6 trigged-hello-delay 3
probe-interval (IPv6 PIM view)
Syntax probe-interval interval
undo probe-interval
View IPv6 PIM view
Parameter interval: Register probe time in seconds, with an effective range of 1 to 3,600.
Description Use the
probe-interval command to configure the register probe time.
Use the
undo probe-interval command to restore the default setting.
By default, the register probe time is 5 seconds.
Related command: register-suppression-timeout (IPv6 PIM view).
Example # Set the probe time to 6 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] probe-interval 6
register-policy (IPv6 PIM view)
Syntax register-policy acl6-number
undo register-policy
View IPv6 PIM view
