343
Description Use the dlsw enable command to enable DLSw.
Use the undo dlsw enable command to disable DLSw.
By default, DLSw is enabled.
The execution of the undo dlsw enable command releases all dynamic resources
without altering the configuration.
Example # Disable DLSw without changing the configuration.
<Sysname> system-view
[Sysname] undo dlsw enable
# Enable DLSw.
<Sysname> system-view
[Sysname] dlsw enable
dlsw ethernet-frame-filter
Syntax dlsw ethernet-frame-filter acl-number { inbound | outbound }
undo dlsw ethernet-frame-filter { inbound | outbound }
View System view
Parameter acl-number: Layer 2 ACL number, in the range of 4000 to 4999.
inbound: Specifies to apply the ACL for inbound traffic.
outbound: Specifies to apply the ACL for outbound traffic.
Description Use the
dlsw ethernet-frame-filter command to configure the DLSw router to
filter Ethernet frames from or to the local SNA device by applying the specified
ACL for inbound or outbound traffic.
Use the
undo dlsw ethernet-frame-filter command to remove the ACL
applied for the inbound or outbound traffic.
For more information about a Layer 2 ACL, refer to “IPv4 ACL Configuration
Commands” on page 2087 and “IPv6 ACL Configuration Commands” on page
2103.
Example # Apply ACL 4000 on the DLSw router to filter inbound Ethernet frames.
<Sysname> system-view
[Sysname] dlsw ethernet-frame-filter 4000 inbound
